tva logoTennessee Valley Authority

Reservoir releases improvements

Maintaining a Wetted Riverbed

The problem

When dams on tributary rivers use water from the reservoir upstream to generate power, there is plenty of water in the riverbed downstream. But when the demand for electricity drops off for a few hours each day, power generation—and water flowing through the dam—can stop. When this happens, large areas of previously wetted riverbed are exposed for hours at a time, until the next release from the upstream dam. The result of prolonged exposure is the loss of aquatic habitat and a decrease in the abundance and availability of food, conditions that affect the health and fitness of the fish that live in the water below the dam, or tailwater.

The solutions

TVA uses three different technologies to maintain water flow in the riverbed below tributary dams when hydroelectric generation is shut off:

Turbine pulsing

At some dams, TVA releases water through the dams at regular intervals throughout the day, called pulsing. This helps to create an essentially steady flow of water within a few miles, maintaining a more constant wetted habitat downstream of the dams.

Weirs

At other dams, TVA has built downstream weirs. These operate like small dams, holding back some of the water when power is being generated, then slowly releasing it when generation stops.

Small hydroelectric units

At two TVA hydropower plants (Blue Ridge and Nottley), small hydroelectric units run when the main turbine is not operating so that water is continuously released downstream.

 

Tributary dams

To see what TVA is doing about the problems of low oxygen concentrations and low flows at tributary dams, choose from the list below.

Main-river dams

View information on improvements at main-river dams.

 

           
Content for id "future1" Goes Here
Content for id "future2" Goes Here
Content for id "future3" Goes Here